The Esfera exterior wood protection series is water-based. These products, which are ready to use, are very easy to apply. The impregnation series, which does not create a film layer on the wood, penetrates deeply into the wood and colors it while preserving its natural texture. By its impregnation feature, it prevents cracking and partial breakage.
Coloured Wood Preservatives Impregnation Series
7034xx Esfera Exterior Wood Protective Products (Impregnation)
Packing Volume
- 1 L
- 2,5 L
- 20 L
Water-based, EN 71-3 certified, ready-to-use and easy-to-apply varnish, penetrates deeply into the wood, preserves the natural texture, protects against fungus and UV rays, creates a homogeneous coloured appearance, shows high resistance to environmental influences, and dries quickly.
Water
based.
based.
It provides safe application and use-area
with EN 71-3 Certificate.
with EN 71-3 Certificate.
Easy
application.
application.
Ready
to use
to use
No film
layer.
layer.
It penetrates deeply
into wood.
(3 mm)
into wood.
(3 mm)
Preserving its natural texture, It colors the wood.
Due to its impregnation feature, it prevents ruptures and partial breaks.
It protects the wood’s apperance and texture
With its fungicidal characteristic, it protects the wood from factors that cause deformation such as fungus and mold.
It resists the changes and deteriorations which UV rays may cause on the wood with the help of UV filter content.
With its breathing and water repellent feature, it allows the wood to give interior moisture out, and prevents the wood from excessive moisture.
In case of application on whole surface, it makes the wood highly resistant to environmental effects.
It spreads strongly on the applied surface and provides a homogeneous color appearance.
It has a wide color range that can be mixed with each other. In this way, it can be obtained so many other colors
The desired color tone can be created by water dilution.
Dry fast.
Easy cleaning of application tools.
In the Impregnation Series, which can be easily applied by dipping, pouring, cloth, brush, roller, and spray gun, thinning with 0-15% water can be done depending on the application equipment and application environment conditions.
It is easily applied by dipping, pouring, cloth, brush, roller and airbrush.
Depending on the application equipment and application ambient conditions, it can be thinned with 0-15% water.
1 liter product for 12-18 m2 area at one coat.
Should be used 50-80 gr for area of 1 m2.
The internal moisture values of the wood should be between 10%-12% in soft woods and between 14%-15% in hard woods.
It is highly recommended to use Esfera 70020X Series Topcoat Varnish to increase the resistance of wood to environmental effects.
Dusting drying time is 25-35 minutes, touch drying time is 60-70 minutes, sanding drying time is 3-4 hours and stacking drying time is 24-36 hours; these drying times are determined according to 25°C temperature and 45-65% relative humidity values, but may vary depending on ambient conditions.
Dust hold dry-time is between 15-25minutes.
Touching dry-time is between 30-60 minutes.
No need sanding between coats.
Stacking dry-time (curing) is 16-24 hours.
Overcoat application time is between 1-2 hours.